Before driving a new forklift, please read the user manual and technical information carefully, and maintain and operate the truck according to the user manual. Please note the following during the warranty period:
If the total travel distance reaches 2000-2500km, the new car needs mandatory maintenance, and three routine maintenance must be performed every 5000km in the future.
Please use the lubricant specified in the User Manual.
Only the original charger can be used to charge the truck, otherwise other chargers will affect the battery level and battery life or even damage the battery.
Charge and maintain the battery according to the user’s instructions.
Avoid sharp starts and suddenly accelerate to ensure safety. Use original replacements or parts as this may result in a mismatch in work.
Maintain design load; ensure that the forklift is not overloaded. Avoid sudden braking as much as possible and avoid emergency braking at high speeds. Please keep the tire pressure in line with the design value.
Do not change the forklift structure or add auxiliary equipment not included in the original forklift design (such as adding armored springs, additional electrical equipment, etc.), or failure due to these modifications does not enjoy quality assurance.
Be careful and slow down when driving a forklift or passing through the skid plate on rainy days. The damage caused by the water in the motor system is not guaranteed.
After the driver leaves, do not store valuables in the shopping
forklift. The seller will not be responsible for the theft.
Forklift battery maintenance
The battery surface, cables and bolts should be kept clean and dry. If the electrolyte leaks, wipe it with a clean cotton cloth and rinse with water. Note: During the cleaning process, it is strictly forbidden to inject water into the battery to avoid leakage and increase self-discharge, resulting in operation failure.
The battery connection must be good. Be sure to check the battery connection nut for looseness to avoid sparks or burnout rods.
No items are allowed on the battery to avoid short circuit or damage to the battery. Direct connection between the direct and positive poles is prohibited.
The battery must be charged on the same day after the battery is discharged (no matter how long the drive time is, how far the trip is), do not delay the charge until the next day, and do not charge more than 24 hours. Otherwise it will shorten battery life
When the battery is discharged, the density of the electrolyte increases, and since the liquid surface of the water is electrolyzed and evaporated (especially in summer), the electrolyte or distilled water should be periodically inspected and filled. When approaching a fully charged state, the user needs to adjust the electrolyte density to 1.280 ?? 0.005 (25 ?? C) by filling with distilled water or dilute sulfuric acid having a density of 1.400. This dilute sulfuric acid is a special use for lead-acid batteries. And the liquid surface should be flat with the highest surface line. After completing these steps, continue charging the battery for 0.5-1 hours to ensure a uniform liquid ratio.
Any impurities are not allowed to fall into the battery. The water should be kept clean to prevent impurities from entering the battery. 7. If the forklift is not used for a long time, store the forklift after the battery is fully charged, and charge the battery once every two weeks. The charging time is about 9 hours.
Battery life is generally one to one and a half years. After that, the battery capacity will drop sharply. Please replace it with a new one. All batteries in a group must be of the same brand, same capacity, and similar voltage (after full charge, the maximum voltage difference should be no greater than 0.1V).
Forklift battery maintenance
Keep the battery out of the reach of children.
Do not use batteries that are not intended for use. Doing so may cause the battery to leak, heat or explode beyond its intended use.
It is forbidden to disassemble, modify, destroy, strongly impact or throw the battery, otherwise it may cause the battery to leak, heat and explode.
Prevent the battery from being affected by water, fire and heat
The battery prevents short circuits.
If the total battery voltage exceeds 45V, safety measures such as insulated gloves should be used before work. Failure to do so may result in electric shock.
When maintaining or measuring the battery, keep the proper angle and distance between the face and the battery. Do not point the top right of the battery.
The plate and the separator absorb the sulfuric acid in the battery. If the battery is mechanically damaged, it should prevent the sulfuric acid from coming into contact with the skin, clothing and splashing into the eyes. If this happens, rinse immediately with plenty of water or go to the hospital for examination.
The battery’s operating temperature range is -20~ + 55??C. If the operating temperature is + 5~ + 35??C, the battery life will be longer.
Huaya electric forklift industry has the lowest price, the configuration is exactly the same as the famous brand. Huaya electric forklift is exported to other countries. You are welcome to contact us for the call below. We will provide you with a satisfactory car plan!